PROFINET Controller Module for ControlLogix®
What do you need help with?
I am using a ProSoft MVI46 solution and I am getting a Fault Message that says, "Specialty I/O Module in Slot x has not responded within the time limit." What can cause this?
this issue. 4. Sometimes, moving the module to another slot in the chassis, preferrably closer to the SLC processor may eliminate the fault. The fault may also occur due to a hardware problem within
Read moreWhat Compact Flash card does ProSoft recommend using with my ADM solutions
(or -3512) 256M = SSD-C25MI-3012 (or -3512) 512M = SSD-C51MI-3012 (or -3512) 2G = SSD-C02GI-3012 (or -3512) 4G = SSD-C04GI-3012 (or -3512) This is the approved card from
Read moreWhy is the FTView application not getting any data from the AN-X2-AB-DHRIO Gateway running the RIO HMI firmware?
and select the second processor which should be the L40C. 3) Enter in the IP Address of the AN-X2-AB-DHRIO gateway. 4) Finish the shortcut configuration, and then select the copy from design time to run
Read moreRead Commands from my Modbus Master to a ProSoft MCM Slave are working but Write Commands are failing. How do I fix this?
1200 32 2400 16 4800 8 9600 4 19200 2 28800 2 38400 2 57600 1 115200 1 If you still observe a considerable number of communication errors, try to increase the Guard Band Time value (in
Read moreCan I add the 40Gb IDE hard drive to my PC56-XP to supplement the factory installed 4Gb Compact Flash Card?
Unfortunately, it is not possible to add the 40Gb IDE drive to a PC56-XP that came with a 4Gb Compact Flash (CF) card installed. Due to limitations of the PC56 BIOS, you can use either the CF card ... Can I add the 40Gb IDE hard drive to my PC56-XP to supplement the factory installed 4Gb Compact Flash Card?
Read more