PROFINET Controller Module for ControlLogix®
What do you need help with?
What is the backplane current draw for MVI56, MVI56E, MVI69, MVI46 and MVI71 modules?
The backplane current draw for modules in these series is 800mA at 5.1VDC. Additionally, MVI69 modules are required to be within two slots of a power supply on the 1769 bus.
Read moreHow do I read/write Modbus binary data?
, use Function Code 1. To write Coil bit-level data, use Function Code 5 to write a single Coil (bit), or Function Code 15 to write multiple Coils (bits). For all ProSoft MCM solutions, be sure to use
Read moreWill ProSoft MVI69-xxxx solutions work with the new Allen-Bradley CompactLogix L23 series of processors?
ProSoft MVI69 solutions require a minimum of 800mA of 5vdc current be available from the backplane of any CompactLogix system in which they are installed. Within the 1769-L23x processor family
Read moreWhy is the FTView application not getting any data from the AN-X2-AB-DHRIO Gateway running the RIO HMI firmware?
in FactoryTalk View: 1) Right click on Ethernet driver and select add new device 2) Expand and browse the NetENI connected PCCC devices folder, and then expand and browse the PLC 5 processors folder
Read moreRead Commands from my Modbus Master to a ProSoft MCM Slave are working but Write Commands are failing. How do I fix this?
device in a multidrop network (RS-422 or RS-485 wiring). In RTU mode, when the module receives sequence of data from another node, it will recognize the end of the message when it detects a 3.5 character
Read more