Two-Port Building Automation Gateway
What do you need help with?
How can I edit the backplane exchange size on the MVI56-ADM?
. The last argument of the these two functions (MVIcip_WriteConnected and MVIcip_ReadConnected) is the dataSize argument in size of bytes. The detail on how to use these two functions can be found on page 273
Read moreWhy is the FTView application not getting any data from the AN-X2-AB-DHRIO Gateway running the RIO HMI firmware?
, or is not running the correct firmware. To validate this open the web page for the AN-X2-AB-DHRIO gateway and verify that it is running the AB HMI firmware under the Administration area: Then confirm
Read moreIn the IEC 60870-5-104 protocol, what is the purpose of the "RESET_PROCESS" command, "C_RP_NC_1"; and what does it do?
procedure to close an open socket connection. On page 45 of the protocol specification, it describes the process as: Figure 20 shows the controlling station establishing a connection by giving an Active
Read moreHow do I increase my ReadData array for an MVI56-MCM module?
. For 2000 words of readdata we will need this to be between 1 and 10.The module pages data in blocks of 200 words. The first block has a block index of 1, and contains the first 200 words of data from
Read moreI upgraded my RSLogix5000 software from an older version to Version 16 and now the clock in my MVI56 module does not seem to show the correct time. Why not?
module that supports internal clock functions, especially the MVI56-AFC, MVI56-DNP and any MVI56 modules that support IEC protocols, like 101S, 101M, 103M, 104S, etc. can be affected by this change
Read more