Two-Port Building Automation Gateway
What do you need help with?
The PC56-CE sample program in my eMbedded Visual C, hangs my PC when I select 56SAM_FULL in the Select Active WCE Configuration Combo Box.
This is caused by a bug in Microsoft Embedded Visual C. Download and install Windows XP Service Pack 3 from Microsoft, then reinstall the PC56-CE development kit.
Read moreDoes the ProSoft DNP driver support 32 bit Analog Inputs/Outputs?
Only the MVI56E-DNPNET supports 32 bit analogs, all other modules and gateways return only the low 16 bits. However 32 bit counters and floats are supported by most of our DNP3 products.
Read moreWhat is the affect of different materials blocking a RadioLinx RLX-IH signal?
The increase in attenuation can be as high as 3DB. the following provides some examples of the attenuation values of common office construction: plasterboard wall 3db glass wall with metal
Read moreMy 3150-MCM block IDs are incrementing until I connect the communications cable. Once the cable is connected, the block ID stops incrementing.
Verify the cable matches the diagram on page 50 of the user manual. If pins 7 and 8 are not jumpered, and there is communications on pins 1 or 9, your backplane transfers will fail. The error status
Read moreWhat is the part # and pin-out of the cable that came with my MVI serial module?
The part number for reordering the RJ45 to DB9 adapter cable provided with PLC serial modules is Cable 14. Pinout for the DB9 side: This is a straight thru adapter cable, pin 1-1, 2-2, 3-3, etc
Read more