Two-Port Building Automation Gateway
What do you need help with?
My RLXIB-IHW radio does not seemed to be working at 5GHz. How do I fix it?
If you are using a RadioLinx RLXIB-IHW radio with firmware revision 2.073 and set it to operate at 5GHz, there is a known issue in this version of firmware that causes the transmit power to drop ... My RLXIB-IHW radio does not seemed to be working at 5GHz. How do I fix it?
Read moreIn the IEC 60870-5-104 protocol, what is the purpose of the "RESET_PROCESS" command, "C_RP_NC_1"; and what does it do?
The Reset_Process command is defined in Section 7.1 of the IEC-870-5-104 protocol specification document, the section covering Station Initialization. This command is used as part of the connection ... IEC, 60870, IEC-870-5-104, 104S ... In the IEC 60870-5-104 protocol, what is the purpose of the "RESET_PROCESS" command, "C_RP_NC_1"; and what does it do?
Read moreHow do I change the name and address of the Site Operator in my Opacts/TermLinx application?
the active site as usual. (2) Menu (3) In the window that opens, click "find". (4) In the list to the left, click (highlight) the entry that represents your site (5) In the panel to the right, note
Read moreWhat do the QuickServer LEDs indicate?
in this manner. ERR - This LED will become active during power up temporarily, but should be off within about 5 seconds. If it does not turn off, or if it comes on at any point during normal operation and remains
Read moreHow do I control Binary Outputs Using the MVI56E-DNPNET Module?
_Address 5 DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Object 12 DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Variation 1 DNPNET
Read more