Home » Categories » Protocols » PROFIBUS

Does ProSoft or ProLinx support Profibus PA?

By itself the module does not support PROFIBUS PA. However, when used with a PROFIBUS DP/PA coupler, it is possible to communicate with the ProLinx module via PROFIBUS PA.


Related Keywords:

PROFIBUS PA DP PDPS PDPM

Custom Fields
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Related Articles RSS Feed
    I need to set up a ProSoft PROFIBUS Master to talk to a Siemens S7-300 series CPU that is set up as a PROFIBUS Slave. How do I do that?
    Viewed 1 times since Mon, Feb 18, 2008
    Will the PS69-DPM work with a Siemens 157-xxxxx-0XA0 DP/PA coupler at the baud rate 45.45 Kbit/s?
    Viewed 1 times since Wed, Apr 11, 2012
    How do I setup my 3170-PDP in Step 7 software?
    Viewed 1 times since Tue, Nov 28, 2006
    I am trying to download my PROFIBUS PDPMV1 Master/Slave configuration from the ProSoft Configuration Builder (PCB) "PROFIBUS - PDPMV1" Online-Download Configuration menu option; and it is lo
    Viewed 1 times since Tue, Mar 18, 2008
    SYCON registration number
    Viewed 1 times since Tue, Nov 28, 2006
    Can a ProSoft PROFIBUS DP v1 Master solution communicate directly with other PROFIBUS DP v1 Masters?
    Viewed 1 times since Wed, Mar 5, 2008
    I have a PROFIBUS DP network with ProSoft PROFIBUS DP Master solution that appears to be operating normally (no bus faults, slaves report "OK"), but I am unable to control my devices. What
    Viewed 1 times since Thu, Apr 24, 2008
    My Profibus Master (PDPMV1) card is not communicating and will not go into RUN mode but does not show an error in the ProSoft Configuration Builder software, why?
    Viewed 1 times since Thu, Apr 7, 2011
    I can't get my ProSoft PROFIBUS DP V1 Master to talk to all of the Slave Nodes on my PROFIBUS network. What might the problem be?
    Viewed 1 times since Thu, Sep 4, 2008
    How can I monitor module and slave status with the MVI56-PDPV1 and other PDPMV1 PROFIBUS master modules?
    Viewed 1 times since Wed, Nov 29, 2006