Home » Categories » Protocols » PROFIBUS |
I need to set up a ProSoft PROFIBUS Master to talk to a Siemens S7-300 series CPU that is set up as a PROFIBUS Slave. How do I do that? |
Article Number: 367 | Rating: 1/5 from 1 votes | Last Updated: Mon, Feb 18, 2008 at 12:00 AM |
The attached file shows how to set up a S7-315 CPU to be a PROFIBUS DP Slave to a ProSoft MVI56-PDPMV1 PROFIBUS Master and was written for that specific application. However, many of the setup steps apply to other S7 configurations and other ProSoft PROFIBUS Masters. Please see the attached file. |
Attachments (1)
![]()
|
Comments
![]()
There are no comments for this article. Be the first to post a comment.
|
I am trying to download my PROFIBUS PDPMV1 Master/Slave configuration from the ProSoft Configuration Builder (PCB) "PROFIBUS - PDPMV1" Online-Download Configuration menu option; and it is lo
Viewed 1 times since Tue, Mar 18, 2008
Will the PS69-DPM work with a Siemens 157-xxxxx-0XA0 DP/PA coupler at the baud rate 45.45 Kbit/s?
Viewed 1 times since Wed, Apr 11, 2012
What is Profibus?
Viewed 1 times since Thu, Apr 12, 2007
Can a ProSoft PROFIBUS DP v1 Master solution communicate directly with other PROFIBUS DP v1 Masters?
Viewed 1 times since Wed, Mar 5, 2008
My Profibus Master (PDPMV1) card is not communicating and will not go into RUN mode but does not show an error in the ProSoft Configuration Builder software, why?
Viewed 1 times since Thu, Apr 7, 2011
SYCON registration number
Viewed 1 times since Tue, Nov 28, 2006
How to resolve an issue where Siemens Step 7 software displays a message indicating that the ProSoft GSD file cannot be interpreted.
Viewed 1 times since Wed, Nov 29, 2006
How do I setup my 3170-PDP in Step 7 software?
Viewed 1 times since Tue, Nov 28, 2006
Can a ProSoft PROFIBUS DP v1 Master solution also be configured as a Slave to another Master?
Viewed 1 times since Wed, Mar 5, 2008
Does ProSoft or ProLinx support Profibus PA?
Viewed 1 times since Tue, Nov 28, 2006
|