Home » Categories » Protocols » PROFIBUS

How do I setup my 3170-PDP in Step 7 software?
Article Number: 129 | Rating: Unrated | Last Updated: Fri, Jan 18, 2008 at 12:00 AM
Make sure to drop the "3170-PDP 1.2 status" information into the first slot, then each of your I/O modules after that. Any unused slots must have a "flex I/O empty slot" defined in the configuration for that slot setup.
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 11:03 AM This article has been viewed 51178 times.
    Filed Under: PROFIBUS
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    Does ProSoft or ProLinx support Profibus PA?
    Viewed 1 times since Tue, Nov 28, 2006
    Will the PS69-DPM work with a Siemens 157-xxxxx-0XA0 DP/PA coupler at the baud rate 45.45 Kbit/s?
    Viewed 1 times since Wed, Apr 11, 2012
    I can't get my ProSoft PROFIBUS DP V1 Master to talk to all of the Slave Nodes on my PROFIBUS network. What might the problem be?
    Viewed 1 times since Thu, Sep 4, 2008
    How can I monitor module and slave status with the MVI56-PDPV1 and other PDPMV1 PROFIBUS master modules?
    Viewed 1 times since Wed, Nov 29, 2006
    What is Profibus?
    Viewed 1 times since Thu, Apr 12, 2007
    I am trying to download my PROFIBUS PDPMV1 Master/Slave configuration from the ProSoft Configuration Builder (PCB) "PROFIBUS - PDPMV1" Online-Download Configuration menu option; and it is lo
    Viewed 1 times since Tue, Mar 18, 2008
    SYCON registration number
    Viewed 1 times since Tue, Nov 28, 2006
    Can a ProSoft PROFIBUS DP v1 Master solution communicate directly with other PROFIBUS DP v1 Masters?
    Viewed 1 times since Wed, Mar 5, 2008
    I have a PROFIBUS DP network with ProSoft PROFIBUS DP Master solution that appears to be operating normally (no bus faults, slaves report "OK"), but I am unable to control my devices. What
    Viewed 1 times since Thu, Apr 24, 2008
    My Profibus Master (PDPMV1) card is not communicating and will not go into RUN mode but does not show an error in the ProSoft Configuration Builder software, why?
    Viewed 1 times since Thu, Apr 7, 2011
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software