KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

Connecting to the RJ-45 connectors on an MVI module

Article Number: 26 | Rating: 1/5 from 14 votes | Last Updated: Fri, Jan 18, 2008 at 12:00 AM

The MVI modules are shipped with adapter cables which convert the RJ-45 connector on the module to a standard DB9 male connector.

Related Keywords:

RJ45 RJ-45 MVI46 MVI56 MVI71

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

Establishing RS-485 communications

Viewed 1 times since Tue, Nov 28, 2006

What cable should be used for RS-485 communications?

Viewed 1 times since Tue, Nov 28, 2006

Can the rubber boot on the RJ45 end of the ProSoft RJ45 to DB9M adapter cable cause communication disruption?

Viewed 1 times since Fri, Feb 8, 2008

What are the pin-outs for the 1455-RS232 (RS232 to RS485 Passive Converter)?

Viewed 1 times since Wed, May 5, 2010

Are terminating resistors necessary on my RS-485 network?

Viewed 1 times since Tue, Nov 28, 2006

What are the pin outs for the RJ-45 jack on my Prosoft MVI module?

Viewed 1 times since Tue, Nov 28, 2006

Connecting to the Mini-DIN connectors on a ProLinx module

Viewed 1 times since Tue, Nov 28, 2006

How many Modbus devices can I connect to my MCM module?

Viewed 1 times since Tue, Nov 28, 2006

I have a device that expects power to be provided through a serial or Ethernet connection. Do ProSoft communciations solutions provide such power?

Viewed 1 times since Mon, Feb 18, 2008

What cable should I use for RS-485?

Viewed 1 times since Tue, Nov 28, 2006