KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

What are the pin-outs for the 1455-RS232 (RS232 to RS485 Passive Converter)?

Article Number: 441 | Rating: Unrated | Last Updated: Wed, May 5, 2010 at 2:04 PM

See Attachment

Custom Fields

Attachments (1)

Attachments

1455_rs232touserinsert_bkd.pdf ( 3548 Views, 505.95 KB )

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

How can I connect my 4 wire RS-485 device to my ProSoft communication device?

Viewed 1 times since Tue, Nov 28, 2006

What cable should be used for RS-485 communications?

Viewed 1 times since Tue, Nov 28, 2006

Connecting to the Mini-DIN connectors on a ProLinx module

Viewed 1 times since Tue, Nov 28, 2006

Establishing RS-485 communications

Viewed 1 times since Tue, Nov 28, 2006

What cable should I use for RS-485?

Viewed 1 times since Tue, Nov 28, 2006

Can the rubber boot on the RJ45 end of the ProSoft RJ45 to DB9M adapter cable cause communication disruption?

Viewed 1 times since Fri, Feb 8, 2008

Connecting to the RJ-45 connectors on an MVI module

Viewed 1 times since Tue, Nov 28, 2006

What are the pin outs for the RJ-45 jack on my Prosoft MVI module?

Viewed 1 times since Tue, Nov 28, 2006

Are terminating resistors necessary on my RS-485 network?

Viewed 1 times since Tue, Nov 28, 2006

When using the 1451-9F terminal connector with my 3150 module, do I need to jumper pins 7 and 8 as shown in the manual?

Viewed 1 times since Tue, Nov 28, 2006