KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

Where is the configuration for the MVI56(E)-MCM?

Article Number: 509 | Rating: Unrated | Last Updated: Tue, Aug 12, 2014 at 11:34 PM

The MVI56(E)-MCM is configured via controller scoped tags that are automatically generated when the rung of ladder is imported into RSLogix 5000. This rung of ladder also contains the AOI that is used to transport data back and forth to the MVI56(E)-MCM module.

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

How to avoid slow data updates on a Modbus network with an MVI56(E)-MCM or MVI69-MCM when some Slaves are either not on-line or not functioning correctly?

Viewed 1 times since Wed, Mar 19, 2008

What causes a conditional command to be issued?

Viewed 1 times since Tue, Nov 28, 2006

Apparent data corruption in 33 words of MVI56-MCM or MVI56E-MCM ReadData or WriteData arrays.

Viewed 1 times since Tue, Nov 28, 2006

How to configure more than 100 commands per port when using an MVI46-MCM, MVI69-MCM, or the MVI56-MCM as a Modbus master?

Viewed 1 times since Tue, Nov 28, 2006

Do the serial ports on my MVI56 module provide any electrical isolation?

Viewed 1 times since Tue, Nov 28, 2006

What is the difference between the MVI56-MCM and the MVI56-MCMR?

Viewed 1 times since Tue, Nov 28, 2006

Where are the on-board jumper positions defined for my MVI module?

Viewed 1 times since Tue, Nov 28, 2006

Bulletin 1-5165141 MVI56-MCM getting intermittent communications errors when operating on both ports

Viewed 1 times since Wed, Nov 29, 2006

Which ProSoft products can communicate with a Honeywell DCS System?

Viewed 1 times since Tue, Jan 22, 2008

What is the purpose of the UseGuardBand/GuardBandTime or InterCharacterDelay parameters in an MCM module?

Viewed 1 times since Tue, Nov 28, 2006