Home » Categories » Multiple Categories

When I increase the ReadData or WriteData array sizes in my program, all of the configuration parameter values go to 0.
Article Number: 33 | Rating: Unrated | Last Updated: Wed, Jul 9, 2014 at 9:41 PM
When controller tag array sizes are changed in the ControlLogix platform, RSLogix5000 re-initializes all of the tags within that data type. This sets all values to 0 in all tags within that group. Before changing any controller tag array sizes, the user should record all configuration parameter values, and re-enter those values after the array size has been changed.
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 8:51 AM This article has been viewed 52237 times.
    Filed Under: MVI56-GSC, MVI56-MCM, MVI56E-GSC, MVI56E-MCM
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    What is the difference between your MVI56E-MCM and MVI56E-MCMR modules?
    Viewed 1 times since Tue, Jan 23, 2007
    What is the best ProSoft solution for communicating to devices that use the Siemens USS ASCII-based protocol?
    Viewed 1 times since Mon, Feb 18, 2008
    Which ProSoft products can communicate with a Honeywell DCS System?
    Viewed 1 times since Tue, Jan 22, 2008
    Bulletin 1-5165141 MVI56-MCM getting intermittent communications errors when operating on both ports
    Viewed 1 times since Wed, Nov 29, 2006
    Baud rate entries greater than 32767 in ProSoft Modules
    Viewed 1 times since Tue, Nov 28, 2006
    How do I convert ASCII data to a Floating-Point value in a Logix based processor?
    Viewed 1 times since Tue, Nov 28, 2006
    How to avoid slow data updates on a Modbus network with an MVI56(E)-MCM or MVI69-MCM when some Slaves are either not on-line or not functioning correctly?
    Viewed 1 times since Wed, Mar 19, 2008
    Do the serial ports on my MVI56 module provide any electrical isolation?
    Viewed 1 times since Tue, Nov 28, 2006
    What causes a conditional command to be issued?
    Viewed 1 times since Tue, Nov 28, 2006
    Apparent data corruption in 33 words of MVI56-MCM or MVI56E-MCM ReadData or WriteData arrays.
    Viewed 1 times since Tue, Nov 28, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software