KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

How do I convert ASCII data to a Floating-Point value in a Logix based processor?

Article Number: 100 | Rating: Unrated | Last Updated: Wed, Feb 25, 2015 at 5:25 PM

ASCII data acquired by the GSC module will be stored in the ReadString SINT (8 bit integer) array.

This data can by copied to a string type tag, and then converted to a real (floating-point) value using the RSLogix 5000 STOR function.

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

How do I get my Symbol barcode scanner to work with ProSoft MVIxx-GSC or ProLinx ASCII solutions?

Viewed 1 times since Wed, Feb 6, 2008

What are the power requirements for the MVI69 CompactLogix modules?

Viewed 1 times since Tue, Nov 28, 2006

Do the serial ports on my MVI56 module provide any electrical isolation?

Viewed 1 times since Tue, Nov 28, 2006

Which of your products support RS-485 serial protocols?

Viewed 1 times since Wed, Feb 6, 2008

Baud rate entries greater than 32767 in ProSoft Modules

Viewed 1 times since Tue, Nov 28, 2006

MicrotLogix processor memory consumption using MVI69-GSC

Viewed 1 times since Tue, Nov 28, 2006

Where are the on-board jumper positions defined for my MVI module?

Viewed 1 times since Tue, Nov 28, 2006

What is the best ProSoft solution for communicating to devices that use the Siemens USS ASCII-based protocol?

Viewed 1 times since Mon, Feb 18, 2008

When I increase the ReadData or WriteData array sizes in my program, all of the configuration parameter values go to 0.

Viewed 1 times since Tue, Nov 28, 2006