KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

How to configure more than 100 commands per port when using an MVI46-MCM, MVI69-MCM, or the MVI56-MCM as a Modbus master?

Article Number: 91 | Rating: 1/5 from 5 votes | Last Updated: Thu, Jul 3, 2014 at 9:16 PM

Master command list contains up to 100 individual entries. Event command control blocks may be used to send additional Modbus commands directly from the ladder logic to one of the master ports.

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

Bulletin 1-5165141 MVI56-MCM getting intermittent communications errors when operating on both ports

Viewed 1 times since Wed, Nov 29, 2006

Baud rate entries greater than 32767 in ProSoft Modules

Viewed 1 times since Tue, Nov 28, 2006

What causes a conditional command to be issued?

Viewed 1 times since Tue, Nov 28, 2006

How to avoid slow data updates on a Modbus network with an MVI56(E)-MCM or MVI69-MCM when some Slaves are either not on-line or not functioning correctly?

Viewed 1 times since Wed, Mar 19, 2008

Where is the configuration for the MVI56(E)-MCM?

Viewed 1 times since Wed, Jul 9, 2014

I was not using both Modbus ports on my MVI56-MCM module, so I set all the port parameters for the unused port to zeros to disable the port and now my module is faulted and will not restart. Why?

Viewed 1 times since Tue, Nov 28, 2006

Where are the on-board jumper positions defined for my MVI module?

Viewed 1 times since Tue, Nov 28, 2006

How can I configure the module to store and initialize input values on reset or powerup?

Viewed 1 times since Tue, Nov 28, 2006

Do the serial ports on my MVI56 module provide any electrical isolation?

Viewed 1 times since Tue, Nov 28, 2006

What is the difference between the MVI56-MCM and the MVI56-MCMR?

Viewed 1 times since Tue, Nov 28, 2006