Home » Categories » Multiple Categories |
What do the jumpers do on the PLX3x gateways? |
Article Number: 525 | Rating: 1/5 from 1 votes | Last Updated: Fri, Mar 6, 2015 at 4:59 PM |
By default the PLX3x gateway should have the jumper in a vertical position, which places the gateway into a normal operational state.
Mode 2 is used to reset the gateway to the default IP Address. To place the gateway into Mode 2 follow these steps: 1) Power down the gateway 2) Place the jumper in mode 2 (horizontally on the middle pins) 3) Power up the gateway At this point the gateway will use the default IP Address of 192.168.0.250, where it is possible to upload and download configuration files using ProSoft Configuration Builder. (Note that until the jumper is placed back into a vertical position the IP address will stay at the default. After making necessary changes power down the gateway, replace the jumper, and then apply power.) Mode 1 should only be used when directed so by Technical Support as it is used to update the firmware on the gateway. |
Attachments (0)
![]()
There are no attachments for this article.
|
Comments
![]()
There are no comments for this article. Be the first to post a comment.
|
Which Ethernet Port is used for uploading and downloading configurations?
Viewed 1 times since Mon, Sep 15, 2014
Configuration Storage on the PLX31 & PLX32 Gateways
Viewed 1 times since Thu, Jun 18, 2015
Differences between the PLX31 & PLX32 Gateways
Viewed 1 times since Fri, Jul 10, 2015
Are the Ethernet port(s) Auto MDI-X ports?
Viewed 1 times since Wed, Sep 24, 2014
How do I get Floating Point (or Double INT or Unsigned INT) data?
Viewed 1 times since Wed, Nov 29, 2006
Why are my PLX gateway modbus serial commands not executing despite being enabled?
Viewed 1 times since Wed, Aug 12, 2015
Cannot Download from PC to Device in ProSoft Configuration Builder
Viewed 1 times since Tue, Dec 1, 2015
SD Card Support on the PLX31 & PLX32 Series Gateways
Viewed 1 times since Fri, May 22, 2015
Which of your products support RS-485 serial protocols?
Viewed 1 times since Wed, Feb 6, 2008
I cannot locate the .EDS file for my ProSoft Product. Where can I get the proper .EDS file for my module?
Viewed 1 times since Thu, May 5, 2016
|