Home » Categories » Multiple Categories |
How does the gateway know where to load or store configuration files (SD card or non-volatile RAM)? |
Article Number: 530 | Rating: Unrated | Last Updated: Wed, Jun 8, 2016 at 7:04 PM |
When the PLX3x gateway boots it checks for an SD card. If an SD card is present it will load the configuration file stored on the SD card. If an SD card is not present than the gateway will load the configuration file from the non-volatile RAM in the PLX3x gateway.
Note: When downloading configurations to the gateway the same principal applies. If an SD card is present than the configuration will only be written to the SD card. If an SD card is not present than the configuration will be written into non-volatile RAM. |
Attachments (0)
![]()
There are no attachments for this article.
|
Comments
![]()
There are no comments for this article. Be the first to post a comment.
|
I cannot locate the .EDS file for my ProSoft Product. Where can I get the proper .EDS file for my module?
Viewed 1 times since Thu, May 5, 2016
ControlLogix PLC Communications with 4B Watchdog Super Elite via a PLX31-EIP-MBTCP
Viewed 1 times since Tue, Jul 26, 2016
Differences between the PLX31 & PLX32 Gateways
Viewed 1 times since Fri, Jul 10, 2015
Are the Ethernet port(s) Auto MDI-X ports?
Viewed 1 times since Wed, Sep 24, 2014
Cannot Download from PC to Device in ProSoft Configuration Builder
Viewed 1 times since Tue, Dec 1, 2015
Configuration Storage on the PLX31 & PLX32 Gateways
Viewed 1 times since Thu, Jun 18, 2015
How do I get Floating Point (or Double INT or Unsigned INT) data?
Viewed 1 times since Wed, Nov 29, 2006
SD Card Support on the PLX31 & PLX32 Series Gateways
Viewed 1 times since Fri, May 22, 2015
Which Ethernet Port is used for uploading and downloading configurations?
Viewed 1 times since Mon, Sep 15, 2014
What do the jumpers do on the PLX3x gateways?
Viewed 1 times since Mon, Sep 15, 2014
|