Home » Categories » Gateways » PLX32 Gateways |
Which Ethernet Port is used for uploading and downloading configurations? |
Article Number: 526 | Rating: Unrated | Last Updated: Mon, Sep 15, 2014 at 6:21 PM |
The first Ethernet port must be used to upload and download configuration files. It is not possible to use the second Ethernet port for this functionality. |
Attachments (0)
![]()
There are no attachments for this article.
|
Comments
![]()
There are no comments for this article. Be the first to post a comment.
|
How do I get Floating Point (or Double INT or Unsigned INT) data?
Viewed 1 times since Wed, Nov 29, 2006
I cannot locate the .EDS file for my ProSoft Product. Where can I get the proper .EDS file for my module?
Viewed 1 times since Thu, May 5, 2016
Cannot Download from PC to Device in ProSoft Configuration Builder
Viewed 1 times since Tue, Dec 1, 2015
Are the Ethernet port(s) Auto MDI-X ports?
Viewed 1 times since Wed, Sep 24, 2014
What do the jumpers do on the PLX3x gateways?
Viewed 1 times since Mon, Sep 15, 2014
Why are my PLX gateway modbus serial commands not executing despite being enabled?
Viewed 1 times since Wed, Aug 12, 2015
Which of your products support RS-485 serial protocols?
Viewed 1 times since Wed, Feb 6, 2008
How does the gateway know where to load or store configuration files (SD card or non-volatile RAM)?
Viewed 1 times since Mon, Sep 29, 2014
Differences between the PLX31 & PLX32 Gateways
Viewed 1 times since Fri, Jul 10, 2015
Configuration Storage on the PLX31 & PLX32 Gateways
Viewed 1 times since Thu, Jun 18, 2015
|