| KB Home | Advanced Search | News | Ask Question |
|
| ProSoft Knowledge Base | |
|
Category Articles 
Does the AN-X(2)-GENI support both Phase A and Phase B GE Genius I/O Blocks?
Viewed 1 times since Fri, Feb 20, 2015
Yes the AN-X(2)-GENI gateway supports both Phase A and Phase B Genius I/O blocks. Please note that they must be used in a valid Genius Bus configuration. Read More
Does the AN-X2-GENI support Ghost Mode?
Viewed 1 times since Mon, Aug 25, 2014
Yes the AN-X2-GENI does support Ghost Mode, however it requires a valid station address on the GE Genius bus network. The main purpose of "Ghost Mode" is to enable the programming and debugging of a new ControlLogix or CompactLogix processor while... Read More
Can an application have redundant AN-X2-GENI gateways scanning the GE Genius Bus Network(s)?
Viewed 1 times since Fri, Jun 27, 2014
The AN-X2-GENI gateway can be used in a redundant scanner configuration with either a single GE Genius Bus network, or with a redundant network configuration. In a redundant media configuration the GE Genius Bus I/O must be implemented with GE... Read More
Does the AN-X(2)-GENI gateway work with VersaMax I/O?
Viewed 1 times since Tue, Aug 5, 2014
Yes the AN-X(2)-GENI gateway supports standard digital and analog I/O modules that are in a chassis with a VersaMax Network Interface. Read More
What should the AN-X(2)-GENI be defined as for global data transactions in the GE Programming software?
Viewed 1 times since Thu, Feb 19, 2015
It is best to configure the AN-X(2)-GENI as a GE 90 30 processor for the global data exchanges. Read More
|
|