What do you need help with?
Coil / Bit Addressing with a ProSoft inRAx Module
Holding/Input register access. But when using Coils, you must use "1 bit addressing". So, for example, if you want to write a coil to address 0001, on your Modbus device using FC 0x5, and you store
Read moreMonitoring the health of HART devices on the PLX51-HART-4I and PLX51-HART-4O Gateways
PLX51HART4IN.MultiDrop[0].PollStatus.0 you will notice that it will be a 1, when the device is polling, and a 0 when it is not...for any reason. Legacy Polling If you using Legacy polling on your
Read moreConnectivity issues when subnet on VPN client collides with existing network configuration
To make this work correctly, configure your home network to be 192.168.1.x/24, leaving the LAN side of the Belden Horizon Gateway to be 192.168.0.x/24. This will avoid any route conflicts, and send all
Read moreI'm getting an Error: Unknown Object, What does this mean?
not do what we requested because at least one of the objects we requested was not defined for them. So for example, if I requested the present value of AI 1, AI 2, and AI 3 from a device, but the device
Read moreI cannot locate the .EDS file for my ProSoft Product. Where can I get the proper .EDS file for my module?
of this. we do not provide .EDS files for every product which could support them. If you are in a situation where an .EDS file is required for a specific product, visit the product page off the main http
Read more