Home » Categories » Protocols » PROFIBUS

Can a ProSoft PROFIBUS DP v1 Master solution also be configured as a Slave to another Master?
Article Number: 376 | Rating: Unrated | Last Updated: Wed, Mar 9, 2011 at 2:58 PM
Sorry; but this is not possible.  However, a ProSoft PROFIBUS DP v1 Master can be configured to pass data to and from another PROFIBUS DP Master by using a third-party DP-to-DP coupler.
Custom Fields
    Posted by: Administrator - Wed, Mar 5, 2008 at 4:22 PM This article has been viewed 19024 times.
    Filed Under: PROFIBUS
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    How to resolve an issue where Siemens Step 7 software displays a message indicating that the ProSoft GSD file cannot be interpreted.
    Viewed 1 times since Wed, Nov 29, 2006
    I need to set up a ProSoft PROFIBUS Master to talk to a Siemens S7-300 series CPU that is set up as a PROFIBUS Slave. How do I do that?
    Viewed 1 times since Mon, Feb 18, 2008
    I can't get my ProSoft PROFIBUS DP V1 Master to talk to all of the Slave Nodes on my PROFIBUS network. What might the problem be?
    Viewed 1 times since Thu, Sep 4, 2008
    SYCON registration number
    Viewed 1 times since Tue, Nov 28, 2006
    How do I setup my 3170-PDP in Step 7 software?
    Viewed 1 times since Tue, Nov 28, 2006
    Does ProSoft or ProLinx support Profibus PA?
    Viewed 1 times since Tue, Nov 28, 2006
    Will the PS69-DPM work with a Siemens 157-xxxxx-0XA0 DP/PA coupler at the baud rate 45.45 Kbit/s?
    Viewed 1 times since Wed, Apr 11, 2012
    I have a PROFIBUS DP network with ProSoft PROFIBUS DP Master solution that appears to be operating normally (no bus faults, slaves report "OK"), but I am unable to control my devices. What
    Viewed 1 times since Thu, Apr 24, 2008
    My Profibus Master (PDPMV1) card is not communicating and will not go into RUN mode but does not show an error in the ProSoft Configuration Builder software, why?
    Viewed 1 times since Thu, Apr 7, 2011
    Can a ProSoft PROFIBUS DP v1 Master solution communicate directly with other PROFIBUS DP v1 Masters?
    Viewed 1 times since Wed, Mar 5, 2008
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software