Home » Categories » Protocols » PROFIBUS |
I am trying to download my PROFIBUS PDPMV1 Master/Slave configuration from the ProSoft Configuration Builder (PCB) "PROFIBUS - PDPMV1" Online-Download Configuration menu option; and it is lo |
Article Number: 377 | Rating: Unrated | Last Updated: Wed, Mar 9, 2011 at 2:57 PM |
Please do not use the "Online - Download Configuration" menu option from inside the PCB "PROFIBUS - PDPMV1" configuration window. If you do this, it will lock up PCB, requiring you to shut it down and restart it to clear the error. Instead, exit the "PROFIBUS -PDPMV1" configuration window, and use the "Project - Module - Download From PC to Device" option from the Main PCB window. This should work every time without locking up PCB. |
Attachments (0)
There are no attachments for this article.
|
Comments
There are no comments for this article. Be the first to post a comment.
|
What is Profibus?
Viewed 1 times since Thu, Apr 12, 2007
My Profibus Master (PDPMV1) card is not communicating and will not go into RUN mode but does not show an error in the ProSoft Configuration Builder software, why?
Viewed 1 times since Thu, Apr 7, 2011
How do I setup my 3170-PDP in Step 7 software?
Viewed 1 times since Tue, Nov 28, 2006
Can a ProSoft PROFIBUS DP v1 Master solution communicate directly with other PROFIBUS DP v1 Masters?
Viewed 1 times since Wed, Mar 5, 2008
Does ProSoft or ProLinx support Profibus PA?
Viewed 1 times since Tue, Nov 28, 2006
I need to set up a ProSoft PROFIBUS Master to talk to a Siemens S7-300 series CPU that is set up as a PROFIBUS Slave. How do I do that?
Viewed 1 times since Mon, Feb 18, 2008
I have a PROFIBUS DP network with ProSoft PROFIBUS DP Master solution that appears to be operating normally (no bus faults, slaves report "OK"), but I am unable to control my devices. What
Viewed 1 times since Thu, Apr 24, 2008
How can I monitor module and slave status with the MVI56-PDPV1 and other PDPMV1 PROFIBUS master modules?
Viewed 1 times since Wed, Nov 29, 2006
SYCON registration number
Viewed 1 times since Tue, Nov 28, 2006
How to resolve an issue where Siemens Step 7 software displays a message indicating that the ProSoft GSD file cannot be interpreted.
Viewed 1 times since Wed, Nov 29, 2006
|