EtherNet/IP™ to DH+ Gateway
What do you need help with?
Coil / Bit Addressing with a ProSoft inRAx Module
Users often have trouble getting Coil writes, using FC5, or FC15 to work correctly in a ProSoft inRAx module, or a ProLinx PLX31 or PLX32 gateway. The following information explains exactly how ... Coil, modbus, fc5, 10001, 0001, fc15, bit, bits, writing coils
Read moreWhen trying to upload a project from Studio 5000 v32 or v33.00 I receive a “Error: Name is invalid” message and the upload fails.
61850C,Studio 5000, Studio 5k, RSLogix, MVI56E-61850, MV156E-61850C, MV156-61850, Studio, Logix Designer
Read moreI cannot locate the .EDS file for my ProSoft Product. Where can I get the proper .EDS file for my module?
of this. we do not provide .EDS files for every product which could support them. If you are in a situation where an .EDS file is required for a specific product, visit the product page off the main http
Read moreWhy can't I download my program to an L3 series controller on Revision 20?
, as shown here at the bottom of page 11: Revision 21 Change Notes Update: February 2016 - Rockwell has released a new Revision 20 series firmware, 20.018, that also fixes the issue for version 20 users.
Read moreCROB functions in serial DNP modules
Example of using a conditional CROB to control BO 3 in slave 2 to using "Latch on" and Latch off" commands. Node address (of the slave) is 2. Object 12 Variation 1 Function 5 (Direct Operate
Read more