Home » Categories » Multiple Categories |
Using AFC modules with corrected (net) flow as in input |
Article Number: 527 | Rating: Unrated | Last Updated: Wed, Dec 31, 2014 at 5:00 PM |
The AFC is not designed to receive a corrected flow input. However if the AFC is being used only for its accumulation and archive capabilities, then rather than the process temperature and pressure inputs, provide the meter's reference conditions as the AFC's temperature and pressure inputs. Typically 15°C and 101.325kPa (SI) or 60°F and 14.73 PSIA (US). |
Attachments (0)
![]()
There are no attachments for this article.
|
Comments
![]()
There are no comments for this article. Be the first to post a comment.
|
What are the power requirements for the MVI69 CompactLogix modules?
Viewed 1 times since Tue, Nov 28, 2006
Do ProSoft AFC flow computer solutions support energy calculations according to the ISO-6976 standards?
Viewed 1 times since Thu, Feb 7, 2008
Downloading a new .AFC project file to an AFC flow computer module.
Viewed 1 times since Tue, Nov 28, 2006
Do ProSoft AFC Flow Computer solutions support "ASME MFc-6M", "API-11" and/or "API-12" calculation standards for measuring lubricating oils?
Viewed 1 times since Tue, Jul 8, 2008
Can an MVI71-AFC or a 2100AGA module to work in a remote rack?
Viewed 1 times since Tue, Nov 28, 2006
Where are the on-board jumper positions defined for my MVI module?
Viewed 1 times since Tue, Nov 28, 2006
Do ProSoft AFC Flow Computers support annubar-type flow sensors?
Viewed 1 times since Tue, Jul 8, 2008
How do I configure a vortex, ultrasonic or coriolis type meter in my AFC module?
Viewed 1 times since Tue, Nov 28, 2006
Do the serial ports on my MVI56 module provide any electrical isolation?
Viewed 1 times since Tue, Nov 28, 2006
|